Setting and Adjusting the
Projector (Settings & Adjustments)
Example: “Picture” screen display for COMPUTER1
2
On these screens, you can make projector settings or adjustments. You can set or adjust the following items:
• Picture Mode | • Setup Guide |
• CLR Temp | • Projection Mode |
• BrilliantColorTM | • Wall Color |
• Film Mode | • OSD Language |
• DNR | • Auto Sync |
• Eco + Quiet | • Auto Power Off |
• Resolution Setting | • Auto Restart |
• Signal Type | • Internal Speaker |
• Dynamic Range | • |
• Video System | • Fan Mode |
• Video Setup | • Quick Start Menu |
• Resize | • COMPUTER2 Select |
• Overscan | • DLP® LinkTM |
• OSD Display | • DLP® LinkTM Invert |
• Background | • All Reset |
Note
•If you click the “Refresh” button before the screen is displayed completely, an error message (“Server Busy Error”) will be displayed. Wait for a moment and then operate again.
•You cannot operate this page while the projector is warming up.
•For details about each item, refer to the projector's operation manual.
Controlling the Projector via LAN
Setting the Security
(Network – Security)
On this screen, you can make settings relating to security.
| Items | Description |
User Name | Setting of user name for security | |
|
| protection. |
Password | Setting of password for security | |
|
| protection. |
Accept IP | It is possible to set up to three IP | |
Address | addresses allowing connection to the | |
|
| projector. |
| All IP | No limits are set to IP addresses |
| Addresses | connecting to the projector. |
| From only | For security improvement, only an IP |
| specifi c IP | address set by “Address |
| addresses | connected to the projector. |
Note
•User Name and Password can be up to 8 characters.
•You can input the characters below:
-19