Sim2 Multimedia HT3000E, 460649000 installation manual Switching the Projector on and OFF

HT3000E

5 SWITCHING THE PROJECTOR ON AND OFF

WARNING: Connect the projector to a power supply with a

nominal voltage within the following values: 100-240 V AC, 50/60 Hz. It must be earthed (Fig. 12).

	Power Switch:
	Position I: On
V	Position 0: Off

Switch on from standby

With the remote control press one of the keys (Fig. 14):

-0 to select the last imput selectet after last switching off.

-1-9 to select the correspondent imput.

With the keypad: press the ON/OFF button.

	S-
PHICS	VIDEO		2
	RGB			S-
		4		VIDEO	1
			REMOTE	AUDIO		OUT

MENU
HDMI1	5

ESC

INPUT

0 I

Power Plug

Fused

Power Socket

3		HV
2)
	G			S-
	RA			V
		PHI			IDEO	2
			CS	RGB	4		S-
							V
								IDEO
								1
						REMO		AUD
						TE
								IOO
								UT

ME
	NU
H
DMI1	5

H	ESC
DMI2	6

Fig. 14

Fig. 12

In position I the projector will initialise itself (red and green leds on) and then goes into standby mode (red led on) (Fig. 13).

M
	EN
	U
H
DMI
1	5

0 I

When the unit is switched on from standby the lamp switches on; after a brief period of warming up, the image displays (blue led on).

If a very short time has passed since the unit was last switched off, the lamp may not switch on beause it is too hot.

Just wait a few minutes for the lamp to cool down sufficiently.

Note:

At power ON the picture could be displayed with a wrong orientation; this is not a fault.

Fig. 13

11