Lamp Power, Power on, Test Patterns | Sim2 Multimedia HT3000E

KE
Y
ST
	ON
20	%	E
20

Fig.26

LAMP POWER

To obtain the greatest picture quality, the LAMP POWER para- meter setting is used to vary the power with which the lamp is supplied. In this way, besides adjusting the brightness of the images to your projection conditions (size and type of screen, environmental brightness), the lamp will have a longer life.

POWER ON

If selected (AUTO), this option allows the system when the projector is connected to the mains power supply.

In STANDBY mode the projector remain in STANDBY mode and awaits the power-up command from the remote control or keypad.

TEST PATTERNS

Displays a series of five test patterns, which are useful when installing the system and checking basic functions. Use the ◀ and ▶ keys to browse through the test patterns (Fig. 27).

Fig.27

INITIAL SETTINGS

Reconfigures the projector to original factory settings except Position, Orientation, Y/C Delay, Zoom and Focus (Fig. 28).

HT3000E

Confirm?

NoYes

Fig.28

MENUS

LANGUAGE

It allow to select the languages available for the On Screen Display menus.

INPUTS LIST

In order to make the HT3000E system increasingly flexible, the functions described below make it possible to modify the inputs selection menu and adapt it so that it matches the require- ments of the user more closely. The main page displays all the inputs physically present on the projector.

You can delete any inputs which are not in use. To do this, select the input in the pull down menu which appears when you press ◀, and choose whether to activate or deactivate the input (Fig.29).

The deactivation or activation of the source results in automatic renumbering of the remaining active inputs.

Imputs
1	VIDEO	1			VIDEO 1
2	S-VIDEO		2		S- IDEO 3	Yes	No
3	COMPONENT / RGBS			3	ACTIVE	Yes	No
3	COMPONENT / RGBS			3	COMP RGB 5
4 GRAPHICS RGB/YPrPb 4					NAME
4 GRAPHICS RGB/YPrPb 4					GRAPH RGB 9
5 HDMI		5			HDMI 5
6 HDMI		6			HDMI 6

Fig. 29

Active video signal sources (shown in the inputs selection menu) are distinguished by tick symbols.

It can useful to identify the input with a user defined name rather than the type of signal (for example, with the name of the connected device).

To do this, in the pull down menu select NAME and rename the source.

This makes it easier to remember which source is connected to a given input; you can use up to 12 alphanumeric characters for the name (for further details, see Entering text).