Sim2 Multimedia 460649000, HT3000E installation manual Connections

HT3000E

Switching off and returning to standby

With the remote control: press .

With the keypad: press .

When switching off, the projector goes into stand-by mode and stores the input selection at the time of switch-off.

The fans keep running until the lamp cools down (green and

red leds on), after which they automatically switch off. Do not switch off the projector with the power switch until the fans have stopped running.

Status	Led blue	Led red	Logo Backlit
Initialisation			Blue Color
Standby			Red Color
On			O￿ / Blue Color (*)
Cooling			Red Color
Error (*)			Red Color

: O￿	: On	: Flashing
		Table 1

6 CONNECTIONS

To obtain the best performance from your projector, we recom-	- Position the cables carefully to avoid a trip hazard - espe-
	cially in low light areas.
mend the use of good quality “video cables” to the various
signal sources (75 ohm Impedance).

Poor quality cables will cause inferior picture performance.

For optimum connectivity we recommend you follow these simple steps:

-With exception of coaxial RCA/Phono type connectors, always double-check that the plug is inserted the correct way round to avoid damaging the plugs or the sockets on the projector (Fig. 15).

-Remove cables by the plug and do not pull on the cable itself.

-Avoid tangled cables.

+
12V
U	R/Cr
SB1.
1	C/Y
		3
	R		B/Cb
	S232		HV
			GR	S-V
			APHI	IDEO	2
			CS	RGB
				4

75

	S-V
	IDEO
	1
REMO	O
TE	AUDI O
	UT

ME
	NU
H
DMI1	5

H		ESC
		IN
DMI2	6
		PUT

Fig. 15

12