RS-232 Control, Vacuum Florescent Display, UP Button

PROJECTOR REAR PANEL INPUTS

7.IR

Wired input from an external remote control.

8.RS-232 CONTROL

Connection for an external RS-232 controller device to place the Projector under system automation control.

9.VACUUM FLORESCENT DISPLAY

Reads out all relevant status information of the Projector at all times. Can be used instead of the On Screen Display. Indicates the model number, current source, scan rate (resolution) and aspect ratio.

10.UP BUTTON

Use to direct select aspect ratios or move the menu cursor Up in the On-Screen Display. When no menus are present on-screen, the UP button will toggle you through aspect ratios in the following order:

Anamorphic → Standard (4:3) → Letterbox → IntelliWide

11.LEFT BUTTON

Used to direct select inputs or move the menu cursor Left in the On Screen Display. When no menu is present on- screen, the LEFT button will toggle you through the different sources, in the order of:

HD Pass Thru 2 → HD Pass Thru 1 → DVI 2 → DVI 1 → HD/RGB2 → HD/RGB1 → Component SD → S-Video 2 → S-Video 1 → Composite

12.DOWN BUTTON

Use to direct select aspect ratios or move the menu cursor Down in the On-Screen Display.

When no menu is present on-screen, this button will toggle you through the different aspect ratios. IntelliWide → Letterbox → Standard (4:3) → Anamorphic

13.ENTER BUTTON

When an item is highlighted on the On-Screen Display, the ENTER button will select the item.

14.RIGHT BUTTON

Used to direct select inputs or move the menu cursor Right in the On Screen Display.When no menus are present on-screen, the RIGHT button will toggle you through the different sources, in the order of:

Composite → S-Video 1 → S-Video 2 → Component SD → HD/RGB 1 → HD/RGB 2 → DVI 1 → DVI 2 → HD Pass Thru 1 → HD Pass Thru 2

15.MENU BUTTON

Pressing the MENU button will bring up the main menu. Also, if you are in an adjustment mode or function, pressing MENU will bring the menu back one level.

16.IR RECEIVER

Receives the IR commands from the remote.

17.POWER INPUT (100-230v)

18.MAIN POWER SWITCH

Disconnects or applies main power to the processor.

19.POWER BUTTON

Press once to toggle on from Standby mode to On mode, a second time to place into Standby mode. For a discreet on or off command, you can use the direct access buttons on the remote control.