32-Port 10/100Mbps Ethernet Switch User Guide
When installing the Switch on a level surface, attach the rubber feet to the bottom of each device. The rubber feet cushion the hub and protect the hub case from scratching.
100 Base-FX Module Installation
The installation procedure for each module is the same. Additional information about each module is provided below.
Use the following steps to install any of the modules (including SC or ST type connectors):
1.Turn power off the switch
2.Locate the module slot in the switch's rear panel.
3.Using a screwdriver, undo the two screws and remove the dust cover on the module slot.
4.Holding the module
5.Using a screwdriver, replace the two screws and tighten until snug.
AirLink+ recommends that you retain the dust cover in case you need to remove the module for an extended period sometime in the future.
Do not use Port 9 and the 100
AirLink+ | 13 |