Connecting the Switch, LED Indicators | Airlink UG-ASW232-1103

32-Port 10/100Mbps Ethernet Switch User Guide

LED Indicators

The LED indicator panel contains the following indicators:

•Power (PWR)⎯This indicator lights green when the switch is receiving power. Otherwise, it is off.

•Full-Duplex/Collision (Full-Duplex/

Collision)⎯This LED indicator lights green when a respective port is in full duplex (FDX) mode. Otherwise, it is blinking when collisions are occurring on the respective port.

•Link/Activity (green/amber)⎯This indicator lights green when the port is connected to a 100Mbps Fast Ethernet station. If the indicator blinks green, data is tranmitted or received on the 100Mbps network. If the indicator lights amber, the port is connected to a 10Mbps Ethernet station. If the indicator blinks amber, data is tranmitted or received on the 10-Mbps network.

•100 BASE-FX Module Indicator (green)⎯This indicator lights up green when a module is installed.

Connecting the Switch

This chapter describes how to connect the Switch to your Fast Ethernet network.

Connecting a PC to the Switch

A PC can be connected to the Switch via a two-pair Category 3, 4, 5 UTP/STP cables. Connect the PC (equipped with a RJ-45 10/100Mbps phone jack) to any of the 32 ports (1 to 32)

AirLink+