Analog Devices 82-000805-01 Miso Disconnect Jumper P6, SMA Connector Clock Disconnect Jumper P10

EZ-Extender Hardware Reference

MISO Disconnect Jumper (P6)

The MISO signal of the serial peripheral interconnect (SPI) connector (J2) is driven by a buffer to the processor’s MISO signal, as illustrated in Figure 2-1 on page 2-2. When the SPI connector is not in use, remove the P6 jumper to prevent the signal from interfering with other devices on the SPI bus.

SMA Connector Clock Disconnect Jumper (P10)

The SMA connector (J3) enables a clock input from a signal generator or from other clock source. The input signal is directed though a buffer, as illustrated in Figure 2-1 on page 2-2. When the SMA connector is not in use, remove the P10 jumper to prevent the buffer from driving other sig- nals on the net.

SHARC EZ-Extender Manual 2-5