ASRock K10N78hSLI-GLAN manual Onboard Headers and Connectors, IDE1

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!

•
Floppy Connector
(33-pin FLOPPY1)
(see p.11, No. 23)	Pin1	FLOPPY1

the red-striped side to Pin1

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.11, No. 8)

	PIN1	IDE1
connect the blue end		connect the black end
to the motherboard		to the IDE devices

80-conductor ATA 66/100/133 cable

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATA II Connectors

(SATAII_1 (PORT0): see p.11, No. 16) (SATAII_2 (PORT1): see p.11, No. 13) (SATAII_3 (PORT2): see p.11, No. 18) (SATAII_4 (PORT3): see p.11, No. 12) (SATAII_5 (PORT4): see p.11, No. 10) (SATAII_6 (PORT5): see p.11, No. 11)

SATAII 5	(PORT4)	SATAII 6	(PORT5)
SATAII 3	(PORT2)	SATAII 4	(PORT3)
SATAII 1	(PORT0)	SATAII 2	(PORT1)

These six Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate.

SATAII_6 (PORT5) connector can be used for internal storage device or be connected to eSATAII connector to support eSATAII device. Please read “eSATAII Interface Introduction” on page 27 for details about eSATAII and eSATAII installation procedures.

21