ASRock K10N78hSLI-GLAN manual Driver Installation Guide, Make a Sata / Sataii driver diskette

2.14 Driver Installation Guide

To install the drivers to your system, please insert the support CD to your optical drive first. Then, the drivers compatible to your system can be auto-detected and listed on the support CD driver page. Please follow the order from up to bottom side to install those required drivers. Therefore, the drivers you install can work properly.

2.15 Installing Windows® XP / XP 64-bit / VistaTM / VistaTM 64-bit Without RAID Functions

If you want to install Windows® XP, Windows® XP 64-bit, Windows® VistaTM or Windows® VistaTM 64-bit on your SATA / SATAII HDDs without RAID functions, please follow below procedures according to the OS you install.

2.15.1 Installing Windows® XP / XP 64-bit Without RAID Functions

If you want to install Windows® XP / Windows® XP 64-bit on your SATA / SATAII HDDs without RAID functions, please follow below steps.

Using SATA / SATAII HDDs and eSATAII devices with NCQ and Hot Plug functions

STEP 1: Set Up BIOS.
A.	Enter BIOS SETUP UTILITY Advanced screen	IDE Configuration.

B.Set the “SATA Operation Mode” option to [non-RAID].

STEP 2: Make a SATA / SATAII driver diskette.

A.Insert the ASRock Support CD into your optical drive to boot your system. (There are two ASRock Support CD in the motherboard gift box pack, please choose the one for Windows® XP / XP 64-bit.)

B.During POST at the beginning of system boot-up, press <F11> key, and then a window for boot devices selection appears. Please select CD-ROM as the boot device.

C.When you see the message on the screen, “Generate Serial ATA driver diskette [YN]?”, press <Y>.

D.Then you will see these messages,

Please choose:

1.Generate AHCI Driver diskette for WindowsXP

2.Generate RAID Driver diskette for WindowsXP

3.Generate AHCI Driver diskette for WindowsXP64

4.Generate RAID Driver diskette for WindowsXP64

5.Exit

Reboot system now

Press any key to continue

35