ACPI HPET Table
Use this item to enable or disable ACPI HPET Table. The default value is [Disabled]. Please set this option to [Enabled] if you plan to use this motherboard to submit Windows® VistaTM certification.
3.3.4 IDE Configuration |
|
| ||
| BIOS SETUP UTILITY |
|
| |
Advanced |
|
|
| |
|
| ENABLED: enables the | ||
IDE Configuration |
| integrated IDE | ||
|
| Controller. | ||
OnBoard IDE Controller | [Enabled] | DISABLED: disables the | ||
integrated IDE | ||||
Onboard SATA Controller | [Enabled] | |||
Controller. | ||||
SATA Operation Mode | ||||
|
| |||
IDE1 Master | [Hard Disk] |
|
| |
IDE1 Slave | [Not Detected] |
|
| |
SATAII_1 | [Not Detected] |
|
| |
SATAII_2 | [Not Detected] |
|
| |
SATAII_3 | [Not Detected] |
| Select Screen | |
SATAII_4 | [Not Detected] |
| ||
| Select Item | |||
SATAII_5 | [Not Detected] |
| ||
+- | Change Option | |||
SATAII_6 | [Not Detected] | |||
F1 | General Help | |||
|
| |||
|
| F9 | Load Defaults | |
|
| F10 | Save and Exit | |
|
| ESC | Exit | |
v02.54 (C) Copyright | ||||
OnBoard IDE Controller
Use this item to enable or disable the “OnBoard IDE Controller” feature.
Onboard SATA Controller
Use this item to enable or disable the “Onboard SATA Controller” feature.
SATA Operation Mode
Use this item to adjust SATA Operation Mode. The default value of this option is
*If you select [RAID] mode, SATA / SATAII HDDs can not be accessed until you finish configuring RAID functions in NVIDIA BIOS / Windows RAID Utility.
*If you install OS on SATA / SATAII HDDs, please do not change the setting of this item after OS installation.
*If you install SATA / SATAII device on eSATAII port and plan to make a floppy image or use Ghost under DOS (Disk Operating System), please set this option to
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will use the “IDE1 Master” as the example in the following instruction, which can be applied to the configurations of “IDE1 Slave” as well.
51
