3. Place the long ÒLÓ side supports over the ends of the short ÒLÓ side supports.
4.Using a 12mm wrench, secure all four ÒLÓ side supports to the saw body with 4 hex bolts, 8 flat washers, 4 lock washers, and 4 hex nuts.
5.Secure each stand leg to the outside of the ÒLÓ side supports with 24 carriage bolts, 24 flat washers, 24 lock washers, and 24 hex nuts (Figure 13).
Stand Leg
Figure 13. Stand leg installation.
6.Secure the flat side supports to the stand legs with 16 carriage bolts, 16 flat washers, 16 lock washers, and 16 hex nuts (Figure 12).
Flat Side Support
Figure 14. Flat side support installation.
Rubber Feet
Components and Hardware Needed: | Qty |
Rubber Feet | 4 |
Hex Nuts | 4 |
Flat Washers 1Ú4" | 4 |
Phillips Head Screws | 4 |
Tools Needed: |
|
10mm Wrench or Socket | 1 |
Phillips Head Screwdriver | 1 |
To install the rubber feet: |
|
1.Using a 10mm wrench and a Phillips head screwdriver, secure each rubber foot to the stand legs with the Phillips head screws, the hex nuts, and the flat washers (Figure 15).
Figure 15. Rubber feet installation.
2.With the help of an assistant, flip the stand rightside up.
3.Final tighten all of the stand fasteners.
G0444/G0444Z 10" Table Saw |
