Grizzly G0444 Service Adjustments, About Service, Blade Parallelism, To do this may result

SECTION 8: SERVICE ADJUSTMENTS

!	Always	disconnect
	power	to the machine
	before	performing ser-
	vice adjustments. Failure
	to do this may result in
	serious personal injury.

About Service

This section is designed to help the operator with adjustments that were made at the factory and that might also need to be made during the life of the machine.

This section is provided for your convenienceÑit is not a substitute for the Grizzly Service Department. If any adjustments arise that are not described in this manual, then feel free to call the Grizzly Service Department at (570) 546-9663.

Similarly, if you are unsure of how to perform any procedure in this section, the Grizzly Service Department will be happy to guide you through the procedures or help in any other way.

Blade Parallelism

To check and adjust blade parallelism:

1.Disconnect the machine from the power source!!

2.Raise the blade to its highest position.

3.Tilt the blade to 90û. Using an adjustable square, measure the distance (A) between the miter slot and the front of the blade as shown in Figure 53.

G0444/G0444Z 10" Table Saw

!

Front

A

Figure 53. 90¡ blade parallelism measurement.

4.Rotate the blade 180° and measure the dis- tance (B) between the miter slot and the back of the blade as shown in Figure 54.

!

Front

B

Figure 54. 90¡ blade parallelism measurement.

5.Make note of the difference between the two measurements on a piece of paper.

-41-