Extension Wings
Components and Hardware Needed: | Qty |
Extension Wings | 2 |
Hex Bolts | 6 |
Lock Washers 7Ú16" | 6 |
Flat Washers 7Ú16" | 6 |
Tools Needed: |
|
17mm Wrench or Socket | 1 |
Straightedge | 1 |
To install the extension wings: |
|
1.Align the extension wing holes with the holes on the cast iron table edges.
2.Using a 17mm wrench, secure the extension wings to the cast iron table with the hex bolts, the lock washers, and the flat washers.
3.Lay a straightedge across the extension wings and cast iron table surface.
ÑIf the straightedge lays flat across all three surfaces, then skip ahead to the next
ÑIf either extension wings tilts down, loosen it and place a strip of masking tape along the bottom edge of the table (Figure 25).
Figure 25. Masking tape location for adjusting
extension table up.
ÑIf either extension wing tilts up, loosen it and place a strip of masking tape along the top edge of the table (Figure 26).
Figure 26. Masking tape location for adjusting
the extension wing down.
4.Tighten the extension wing bolts and repeat step 3.
5.Once all three table surfaces are level, remove the excess masking tape with a razor blade.
G0444/G0444Z 10" Table Saw |
