Grizzly G0444Z Dust Port Handwheels, To install the dust port, To install the handwheels

Dust Port Handwheels

Components and Hardware Needed:	Qty
Dust Port	1
Phillips Head Screws #10-24 x 5Ú8"	2
Hex Nuts #10-24	2
Exterior Tooth Washers #10	2
Toggle Tabs	2
Tools Needed:
8mm Wrench or Socket	1
Phillips Head Screwdriver	1
To install the dust port:

1.Place the dust port in the opening at the base of the saw.

2.Using a Phillips head screwdriver and an 8mm wrench, secure the dust port to the saw with the Phillips head screws, the hex nuts, the exterior tooth washers, and the toggle tabs (Figure 16).

Figure 16. Dust port installation.

Components and Hardware Needed:	Qty
Handwheels	2
Threaded Chrome Handles 3Ú8"-16 x 1Ú2"	2
Star Knobs 3Ú8"-16	2
Tools Needed:
14mm Wrench or Socket	1
To install the handwheels:

1.Thread a chrome handle into each hand- wheel.

2.Using a 14mm wrench, final tighten the han- dles on each handwheel.

3.Slide each handwheel over the threaded shafts that protrude from the side and front of the saw (Figure 17). NoteÑAlign the keyway on the back of each handwheel with the roll pin on the threaded shafts.

Handwheels

Figure 17. Installed handwheel.

4.Secure the handwheels to the threaded shaft with the star knobs (Figure 17).

5.Using the blade tilt handwheel, adjust the trunnion assembly until the bevel scale reads 90û.

-20- G0444/G0444Z 10" Table Saw