G0444Z

110V................................................ NEMA 5-30*

220V (prewired) .............................. NEMA 6-15*

*Not Included

Figure 6. NEMA 5-30 plug and receptacle.

Figure 7. NEMA 6-15 plug and receptacle.

If the circuit breaker trips or the fuse blows regu- larly, your machine may be operating on a circuit that is close to its amperage draw capacity. However, if an unusual amperage draw does not exist and a power failure still occurs, contact a qualified electrician.

Grounding

Electrocution or a fire can result if the machine is not grounded correct- ly. Make sure all electri- cal circuits are ground- ed. DO NOT use the machine if it is not grounded.

NOTICE

The wire on the power cord with green or green and yellow striped insulation is the grounding conductor.

In the event of an electrical short, grounding reduces the risk of electric shock by providing a path of least resistance to disperse electric cur- rent. This tool is equipped with a power cord that has an equipment-grounding prong. The outlet must be properly installed and grounded in accor- dance with all local codes and ordinances.

Circuit Capacity

Always check to see if the wires in your circuit are capable of handling the amperage draw from your machine, as well as any other machines that could be operating on the same circuit. If you are unsure, consult a qualified electrician.

Extension Cords

Because of the high amperage draw from this machine, we do not recommend the use of exten- sion cords. Instead, position machines near installed wiring to eliminate the need for exten- sion cords.

G0444/G0444Z 10" Table Saw

-11-

Page 13
Image 13
Grizzly G0444Z instruction manual Grounding, Circuit Capacity, Extension Cords