G0444/G0444Z 10" Table Saw -21-
Motor
Components and Hardware Needed: Qty
Motor ..................................................................1
Motor Plate ........................................................1
Motor Bracket ....................................................1
Motor Bracket Shaft............................................1
V-Belt Plate ........................................................1
V-Belt Guard ......................................................1
Hex Bolts 5⁄16"-18 x 1 ........................................4
Hex Nuts 5⁄16"-18 ................................................4
Flat Washers 5⁄16" ..............................................8
Lock Washers 5⁄16" ............................................4
Carriage Bolt 1⁄4"-20 x 13⁄4" ................................1
Brass Wing Nut 1⁄4"-20 ......................................1
Speed Nut 1⁄4"....................................................1
Tools Needed:
12mm Wrench or Socket....................................1
10mm Wrench or Socket....................................1
4mm Allen Wrench ............................................1
To install the motor:
1. Using a 12mm wrench, loosely secure the
motor to the motor plate with the hex bolts,
the lock washers, the flat washers, and the
hex nuts (Figure 18).
Figure 18. Installed motor plate.
Motor Plate
2. Slide the carriage bolt through the hole in the
V-belt plate and slide the speed nut over the
carriage bolt end.
3. Slide the v-belt plate between the motor and
the motor plate and over the hex bolts
(Figure 19).
4. Finger tighten the fasteners that secure the
motor to the motor plate.
5. Secure the motor plate to the motor bracket
with the motor bracket shaft (Figure 20).
Note—The hex bolt on the motor bracket
must align with the groove on the motor
bracket shaft.
Figure 19. Installed V-belt plate.
Figure 20. Installed motor bracket.
Motor Bracket Motor Bracket Shaft
V-Belt Plate