Husky Baby Carrier manual Lap Belt Installation

Installation

A

B

C

Lap Belt Installation

Short Route

Figure A illustrates a typical short route lap belt installation.

WARNING:

•Always use recline bar when installing restraint in vehicle using short route with vehicle lap belt.

•Do not install this restraint using a non-locking ELR vehicle belt, unless a belt shortening clip is used. Refer to the vehicle owner's manual for instructions on correct use of vehicle belts with child restraints.

1 Insert recline bar into holes on rear of restraint (see page 20).

2 Place the child restraint in a forward facing position on the vehicle seat.

3Pull the vehicle belt out, then pass it through the first belt slot, from the rear of the restraint to the front (Fig. B).

4Route the vehicle belt under the cover then through the second belt slot, from the front of the restraint to the rear (Fig. C).

5 Verify that the vehicle belt is not twisted, then buckle (Fig. D).

6While kneeling on the restraint to push it firmly into the vehicle backrest, remove all slack from the vehicle belt.

7Verify that the vehicle belt is tight and the child restraint is secure (Fig. E).

Installation can be improved by the use of the Versa-Tether®(see pages 18–19).

IMPORTANT:

•Always use the Versa-Tether for children weighing more than 50 pounds (22.6 kg).

Removal

Reverse installation procedure.

Installation

D

E

16 17