3-10 PC Health Status
This section shows the Status of you CPU, Fan, and Warning for overall system status. This is only available if there is Hardware Monitor onboard.
Phoenix – AwardBIOS CMOS Setup Utility
PC Health Status
Show PC Health in Post |
| Enabled | Item Help | |
Shutdown Temperature |
| Disabled |
| |
smart FAN Configuration |
| Press Enter |
| |
Vcc3.3 | 3.36V | Menu Level > | ||
Vcore | 1.35V | |||
NBVCC | 1.12V |
| ||
+5V | 4.85V |
| ||
+12V | 12.05V |
| ||
5VSB | 12.05V |
| ||
VDIMM | 5.07V |
| ||
CPU Temperature | 34°C |
| ||
SYS Temperature | 32°C |
| ||
CPUFAN Speed | 2550 RPM |
| ||
SYS FAN1 Speed | 0 RPM |
| ||
SYS FAN2 Speed | 0 RPM |
| ||
↑↓→← Move Enter:Select
F5:Previous Values | F6:Optimized Defaults F7:Standard Defaults |
Show PC Health in Post
During Enabled, it displays information list below. The choice is either Enabled or Disabled
Shutdown Temperature
This item can let users setting the Shutdown temperature, when CPU temperature over this setting the system will auto shutdown to protect CPU.
PS CPU Smart FAN Configurations
CPU
This item allows you setting the FAN works in full speed when the temperature over the value which out set. If the temperature below the value but over the Idle Temperature, the FAN will works over 60% of full speed, and the higher temperature will gain higher FAN speed, after over the temperature which this item setting, the FAN works in full speed.
CPU Idle Temp
This item allows you setting the FAN works in 60% of full speed, when the temperature lower than the temperature which you setting.
Current CPU Temperature/Current System Temp/Current FAN1, FAN2 Speed/Vcore/
This will show the CPU/FAN/System voltage chart and FAN Speed.
32