AMD GA-K8N51GMF-RH user manual Fpanel Front Panel Jumper, Faudio Front Audio Panel Connector

8)F_PANEL (Front Panel Jumper)

Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis front panel to the F_PANEL connector according to the pin assignment below.

20 19

English

SPEAK-

Speaker Connector

SPEAK+

			PW-		NC	RES+
Power Switch
		PW+	MSG-		RES-
						HD-
Message LED/		MSG+			HD+
Power/	2			1
Sleep LED

Reset Switch

IDE Hard Disk Active LED

HD (IDE Hard Disk Active LED)	Pin 1: LED anode(+)
	Pin 2: LED cathode(-)
SPEAK (Speaker Connector)	Pin 1: Power
	Pin 2- Pin 3: NC
	Pin 4: Data(-)
RES (Reset Switch)	Open: Normal
	Close: Reset Hardware System
PW (Power Switch)	Open: Normal
	Close: Power On/Off
MSG(Message LED/Power/Sleep LED)	Pin 1: LED anode(+)
	Pin 2: LED cathode(-)
NC	NC

9)F_AUDIO (Front Audio Panel Connector)

If you want to use Front Audio connector, you must remove 5-6, 9-10 Jumper.

In order to utilize the front audio header, your chassis must have front audio connector. Also please make sure the pin assignments for the cable are the same as the pin assignments for the front audio header. To find out if the chassis you are buying support front audio connector, please contact your dealer. Please note, you can have the alternative of using front audio connector or of using rear audio connector to play sound.

		Pin No.	Definition
		1	MIC
10	9	2	GND
		3	MIC_BIAS
2	1	4	POWER
		5	FrontAudio(R)
		6	Rear Audio (R)/ Return R
		7	NC
		8	No Pin
		9	FrontAudio (L)
		10	Rear Audio (L)/ Return L

- 21 - Hardware Installation