AMX AXR-NWS instruction manual Product Information, Specifications

Page 5

Product Information

Product Information

The AXR-NWS NetWave Server is a two-way Radio Frequency (RF) device employing 2.4 GHz digital communications. The AXR-NWS is compatible with both Axcess and NetLinx Integrated Central Controllers, and communicates with up to 16 wireless devices.

The AXR-NWS complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

Specifications

The following table lists the AXR-NWS specifications.

Specifications

Dimensions (HWD)

 

NWS without antenna

1.65" x 5.55" x 6.40" (4.19 cm x 14.10 cm x 16.20 cm)

NWS with antenna

7.41" x 5.55" x 6.40" (18.82 cm x 14.10 cm x 16.20 cm)

Faceplate

1.50" x 5.55" x 0.53" (3.80 cm x 14.10 cm x 1.30 cm)

 

 

Weight

10.56 oz (299.37 g)

 

 

Power Requirement

175 mA @ 12 VDC

 

 

Enclosure

Metal with black anodized matte finish

 

 

Operating Frequency

2.4 GHz RF digital spread-spectrum transmission and reception with up to 16

 

ViewPoints

 

 

Control Compatibility

Axcess Central Controllers

 

NetLinx Central Controllers

 

Landmark Controller

 

 

Front Panel Components:

 

AXlink LED

Green LED that shows power and AXlink communication activity. Blink patterns

 

include:

 

• Off - No power or the controller is not functioning properly.

 

• One blink per second - indicates power is active and AXlink data

 

communication is functional.

 

• Full On - Indicates power is active and AXlink data communication is not

 

functional.

 

 

Status LED

Red LED that lights when an RF link is established with one or more devices.

 

• If the light is On, the Server’s signal is locked and communicating with the

 

ViewPoint.

 

• If the light is Off, the Server is not communicating with the ViewPoint because

 

the signal is either lost or broken.

 

 

RX LED

Yellow LED that lights when the AXR-NWS receives RF control data.

 

 

Group Address

8 position DIP switch that sets the GROUP ADDRESS (0 - 255)

 

 

Group ID

4 position DIP switch that sets the control group identification (0 - 15)

 

 

Rear Panel Components:

 

Antenna

Omni-directional, swivel high-gain RF antenna

 

 

AXR-NWS NetWave Server

1

 

 

 

 

Image 5
Contents AXR-NWS AMX Limited Warranty and Disclaimer Table of Contents Table of Contents Product Information SpecificationsSpecifications Specifications Group ID InstallationGroup Address DIP Switch Values Setting the Group AddressSetting the Device Address on a touch panel Setting the Group Address DIP switchGroup ID DIP Switch Values Setting the Group IDSetting Group ID DIP switches Setting the Group ID on the touch panelPower guidelines Connecting to the ControllerWiring Guidelines Using AXlink for data and powerPreparing captive wires Installing the Control SystemUsing AXlink for data with an auxiliary power supply NWA-EXT Specifications for the Optional NWA-EXTInstallation Replacing the Firmware Chip Firmware UpgradesFirmware Upgrades Installation AXR-NWS NetWave Server AMX,