AMX manual NXP-CPI16 Specifications

Page 6

Specifications

The table below lists the NXP-CPI16 specifications.

NXP-CPI16 Specifications

Power Requirement

12 VDC (300 mA max.)

 

 

Input Connectors:

 

Indicator Power

Two-pin 3.5 mm captive-wire. This connector is used to supply a higher voltage

 

and more current to the power pins of Header 1 and Header 2. The external

 

supply connected to the two-pin captive-wire must be greater than +12 V. If the

 

external supply voltage is less than that, the ICSNet supply (+12 V) will be

 

used for the Power pin of the I/O connectors (not the external supply).

Closure Inputs

 

16 closure inputs activated with a GND or TTL Low (< 0.8 V). Inputs are sam-

 

pled approximately every 10 msec and are debounced in software.

Rotary Encoder Inputs

 

2 quadrature inputs on a 2 x 3 header with a +5 V supply pin (supplying up to

 

100 mA) and a GND pin.

 

 

ICSNet

2 RJ-45 connectors for ICSNet connection

 

 

ID Button

Generates an event from the CPI16 to allow you to assign new Device num-

 

bers, using ID mode in the NetLinx Studio software program.

 

 

LED

ICSP status indicator (green)

 

 

Open Collector Outputs

16 open-collector outputs, acting as a switch to ground, up to 100 mA. Outputs

 

can be connected to voltages ranging between 0 V and +28 V. Each output is

 

updated approximately every 10 msec.

 

 

Dimensions (HWD)

2.75" x 1.75" x 0.062" (69.85 mm x 44.45 mm x 1.557 mm)

 

 

Weight

8.10 oz (229.6 g)

 

 

Accessories

6-pin header with 3 feet (0.91 m) of ribbon cable

 

• Two mating 20-pin headers, each with 3 feet of ribbon cable attached

 

• One green 2-pin 3.5 mm pitch captive wire connector for external indicator

 

power.

 

 

2

NXP-CPI16 NetLinx Custom Panel Interface

Image 6
Contents NXP-CPI16 AMX Limited Warranty and Disclaimer Table of Contents Page Product Information NXP-CPI16Specifications NXP-CPI16 SpecificationsConnector Pinouts Input and Output ConnectorsQuadrature Connectors Quadrature Connector PinoutsQuadrature Inputs Programming Status on Mode Channel AssignmentStatus OFF Mode Channel Assignment LevelsSendCommands SendCommandsLvlsz Qdir Input/Output Status Mode NXP-CPI16 NetLinx Custom Panel Interface System Worksheets CH9 Page It’s Your World Take Control