Introduction, Installation | Airlink101 AKVM-2UA instruction

Ver. 1A

Quick Installation Guide

2-Port USB KVM Switch

Model # AKVM-2UA

Section 1

Introduction

Section 2

Installation

Note: If you use Windows 95/98/SE and have not yet installed a USB mouse on your computer, it is recommended that you install the USB mouse on your computer first before connecting it to the KVM Switch.

You may also need to enable the USB option in the BIOS on some older computers. If your USB interface does not work, please check the USB option status in the computer’s BIOS.

Step 1 Insert the provided Software CD into the CD drive and wait for the autorun page to display.

Note: If the autorun page does not appear go to Start, Run, and type D:\autorun.exe (where D is the letter of your CD drive) and click OK.

Step 2 Click Install USB KVM Switcher on the autorun page.

Step 4 Install the KVM Switcher software on all the computers that will be connected to the KVM.

Step 5 Connect the shared keyboard, monitor, and mouse to the KVM switch. You may also connect speakers and microphone to the KVM switch.

The 2-Port USB KVM Switch enables you to access, control, and reboot multiple USB-enabled multimedia computers using only one USB keyboard, USB mouse, and monitor. Its audio and microphone ports also allows you to share one set of speakers and microphone.

With built-in KVM cables and features such as Plug- and-Play and hot-pluggability, you can enjoy maximum flexibility and convenience with its compact and one- piece design.

Step 3 Follow the on-screen instructions to complete the software installation.

Step 6 Connect each of the built-in KVM cables to a computer’s video and usb ports. You can also connect the cables to the computer’s audio and microphone ports.

Continue on Back