Antec ONE S3 user manual Front I/O Ports, Section, One / One S / One S3 User Manual

Page 15

Section 3

Front I/O Ports

One / One S / One S3 User Manual

15

Image 15

Contents User Manual One / One S / One S3Disclaimer One / One S / One S3 User ManualSection 3 Front I/O Ports Table of ContentsSection 2 Hardware Installation Section 1 IntroductionIntroduction SectionOne / One S / One S3 User Manual Getting to Know Your Chassis Chassis Specifications Included Screws Hardware Installation Removing the Side Panels and Front Bezel Setting UpMotherboard Installation Power Supply Installation Installing KUHLER H2O Liquid CoolersExternal 5.25” Device Installation Secure your drive with the provided 2.5” screws Internal 2.5” Device Installationwhen sliding it in Align your drive’s holes with the drive bay holesCable Management Internal 3.5” Device InstallationFront I/O Ports USB 2.0 pin assignments USB PortsAC’97 / HD Audio Ports Align the connector properly to prevent damage to your motherboardNote Polarity positive and negative does not matter for switches Power Switch / Reset Switch / Hard Disk Drive LED ConnectorsFront panel headers Rewiring Motherboard Header ConnectionsCooling System 120 mm Single Speed Fan Specifications Included FansOptional Fans Front intake 120 mm fanSide 120 mm fan PSU Air Filter Bottom 120/140 mm fanRear 120 mm fan - One S / One S3 only Europe Antec, IncAntec Europe B.V Technical Support