Antec ONE S3 user manual Hardware Installation, Section, One / One S / One S3 User Manual

Page 8

Section 2

Hardware Installation

One / One S / One S3 User Manual

8

Image 8

Contents One / One S / One S3 User ManualOne / One S / One S3 User Manual DisclaimerTable of Contents Section 2 Hardware InstallationSection 1 Introduction Section 3 Front I/O PortsOne / One S / One S3 User Manual IntroductionSection Getting to Know Your Chassis Chassis Specifications Included Screws Hardware Installation Setting Up Removing the Side Panels and Front BezelMotherboard Installation Installing KUHLER H2O Liquid Coolers Power Supply InstallationExternal 5.25” Device Installation Internal 2.5” Device Installation when sliding it inAlign your drive’s holes with the drive bay holes Secure your drive with the provided 2.5” screwsInternal 3.5” Device Installation Cable ManagementFront I/O Ports USB Ports AC’97 / HD Audio PortsAlign the connector properly to prevent damage to your motherboard USB 2.0 pin assignmentsPower Switch / Reset Switch / Hard Disk Drive LED Connectors Note Polarity positive and negative does not matter for switchesRewiring Motherboard Header Connections Front panel headersCooling System Included Fans 120 mm Single Speed Fan SpecificationsSide 120 mm fan Optional FansFront intake 120 mm fan Rear 120 mm fan - One S / One S3 only PSU Air FilterBottom 120/140 mm fan Antec, Inc Antec Europe B.VTechnical Support Europe