Antec ONE S3 user manual One / One S / One S3 User Manual, Disclaimer

Contents One / One S / One S3 User ManualOne / One S / One S3 User Manual DisclaimerSection 1 Introduction Table of ContentsSection 2 Hardware Installation Section 3 Front I/O PortsOne / One S / One S3 User Manual IntroductionSection Getting to Know Your Chassis Chassis Specifications Included Screws Hardware Installation Setting Up Removing the Side Panels and Front BezelMotherboard Installation Installing KUHLER H2O Liquid Coolers Power Supply InstallationExternal 5.25” Device Installation Align your drive’s holes with the drive bay holes Internal 2.5” Device Installationwhen sliding it in Secure your drive with the provided 2.5” screwsInternal 3.5” Device Installation Cable ManagementFront I/O Ports Align the connector properly to prevent damage to your motherboard USB PortsAC’97 / HD Audio Ports USB 2.0 pin assignmentsPower Switch / Reset Switch / Hard Disk Drive LED Connectors Note Polarity positive and negative does not matter for switchesRewiring Motherboard Header Connections Front panel headersCooling System Included Fans 120 mm Single Speed Fan SpecificationsSide 120 mm fan Optional FansFront intake 120 mm fan Rear 120 mm fan - One S / One S3 only PSU Air FilterBottom 120/140 mm fan Technical Support Antec, IncAntec Europe B.V Europe