Antec VSK-1000 user manual Optional Fans

Page 16

4.2

OPTIONAL FANS

There are two optional 120 mm front intake fan mounts at the front of the HDD cage. We recommend using Antec 120

mmspeed control fans and setting the speed to Low. These fans must be installed so that the air is blowing into the case.

Front Fans – You can install two 120 mm fans to the fan cages in front of the hard drive bays. To install the front fans:

1.Remove the front bezel as described in section 2.5

2.Secure your 120 mm fan(s) to the fan holder. The fan should be installed so that air is blowing into the case.

3.Reattach the fan holder to the case by inserting the right side into the corresponding slots on the front of the case, then rotating the holder back into position until it clicks into place.

15

Image 16
Contents K 1 0 0 Congratulations on your purchase of the VSK-1000 Table of Contents Introduction Case Specifications DiagramIncluded Screws Installation Setting UP Power Supply InstallationMotherboard Installation Internal 3.5 Device InstallationExternal 3.25 Device Installation External 5.25 Device InstallationInternal 2.5 Device Installation Remove the right enclosure panel Cable ManagementPorts AC’97 / HD Audio Ports Power Switch / Hard Disk Drive LED Connectors Rewiring Motherboard Header ConnectionsIncluded Fans RPMOptional Fans USA