2.5
EXTERNAL 5.25” DEVICE INSTALLATION
There are three externally accessible 5.25” drive bays. To access these bays, you must first remove the front bezel and drive bay cover:
1.Press on the three tabs pictured to the left to release the front bezel. The bezel should swing outward, like a door.
2.Lay the bezel face down to access the drive bay covers.
3.Remove the drive bay cover as shown below by pressing on the tabs and lifting the cover out of the bezel.
4.Slide your 5.25” device into the bay from the front of the case.
5.Secure the drive into position in the drive cage using the provided screws.
6.Mount any other 5.25” devices accordingly.
7.Connect the appropriate power and data cables to your device(s).
2.6EXTERNAL 3.25” DEVICE INSTALLATION
1.Press on the three tabs to release the front bezel. The bezel should swing outward, like a door.
2.Lay the bezel face down to access the drive bay covers.
3.Remove the drive bay cover as shown below by pressing on the tabs and lifting the cover out of the bezel.
4.Slide your 3.5” device into the bay from the front of the case.
5.Secure the drive into position in the drive cage using the provided screws.
6.Connect the appropriate power and data cables to your device(s).
2.7
INTERNAL 2.5” DEVICE INSTALLATION
At the bottom of your case, there are mounting holes designed to support one 2.5” SSD device.
1.Locate the plastic bag labeled “For 2.5 HDD” and remove the 4 silicone grommets.
2.Install the grommets into the four holes at the base of the case at the bottom of the drive bay area as shown. You should install them with the thick part of the grommets facing the inside of the case.
9