D-Link DES-1012 manual Power Failure

Page 18

10/100 Fast Ethernet Switch User’s Guide

Power Failure

As a precaution, the Switch should be turned OFF in case of a power failure. Press the power switch to the off or “0” position. When power is resumed, turn the Switch ON. At all times, avoid leaving the Switch ON after the occurrence of a power failure.

8	Unpacking and Setup

Image 18

Contents DES-1012 10/100 Fast Ethernet Switch User’s Guide Limited Warranty Hardware Link Offices for Registration and Warranty Service Trademarks Page Table of Contents Viii Terms/Usage About this GuidePurpose Overview of this User’s Guide10/100 Fast Ethernet Switch User’s Guide Introduction Fast Ethernet TechnologySwitching Technology Features Performance Features Unpacking Setup UnpackingSetup Rack InstallationPower On LED IndicatorsPower Failure Identifying External Components Front PanelRear panel view of the Switch Rear PanelLED Indicators Switch LED indicators10/100 Fast Ethernet Switch User’s Guide Connecting Switch PC to SwitchHub to Switch 10Base-T HubHub Without Uplink MDI-II Port 100Base-TX HubConfiguring the Port Speed & Duplex Mode Using a Straight CableUsing a Crossover Cable Switch to Switch Other Devices Console Management Program OverviewNavigating the Console Program Screens Ain M enu Goto system sub menu Configuring the Console Port Submenu Field Description Set port ENABLE/DISABLE Port Counter PKT 10/100 Fast Ethernet Switch User’s Guide Specifications Technical10BaseT Performance Specification RJ-45 PINStandard Category 3 cable, RJ-45 pin assignments Optional 100BASE-FX Module Link SYSTEMS, INC Registration Card