D-Link DES-1016D manual Switch to Hub with Uplink

10/100 NWay Ethernet/Fast Ethernet Switch User’s Guide

The LED indicators for PC connection are dependent on the LAN card capabilities. If LED indicators are not illuminated after making a proper connection, check the PC’s LAN card, the cable, Switch conditions, and connections.

The following are LED indicator possibilities for a PC to Switch connection:

1.The 100Mbps LED indicator comes on for a 100 Mbps connection and stays off for 10 Mbps connection.

2.The Link/Act LED indicator illuminates upon hookup.

Switch to Hub (with Uplink)

A hub (10 or 100BASE-TX) can be connected to the Switch via a two-pair Category 3, 4, 5 UTP/STP straight cable. The connection is accomplished from the hub’s Uplink (MDI-II) port to any of the Switch’s (MDI-X) ports.

Figure 4.2 10/100 NWay Ethernet/Fast Ethernet Switch connected to a 10BASE-T or 100BASE-TX Hub

12 Connecting The Switch