D-Link DES-1016D manual Hub without Uplink MDI-II port, 10BASE-T Hub

Page 23

10/100 NWay Ethernet/Fast Ethernet Switch User’s Guide

10BASE-T Hub

For a 10BASE-T hub, the Switch’s LED indicators should illuminate the following:

♦100Mbps LED speed indicator is OFF.

♦Link/Act indicator is ON.

100BASE-TX Hub

For a 100BASE-TX hub, the Switch’s LED indicators should illuminate the following:

♦100Mbps LED speed indicator is ON.

♦Link/Act is ON.

Hub without Uplink (MDI-II) port

If a hub is not equipped with an Uplink (MDI-II) port, then a connection can be made using either straight cable or crossover cable (see Appendix B, Pin Specification for cable requirement).

Connecting The Switch

13

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Recyclable Wichtige Sicherheitshinweise Limited Warranty Link Offices for Registration and Warranty Service Limitation of Warranties Vcci Warning Bsmi Warning Table of Contents Technical Specifications RJ-45 PIN Specification Overview of this User’s Guide About this GuidePurpose Terms/UsageAbout This Guide Introduction FeaturesPerformance features Unpacking Unpacking SetupDesktop or Shelf Installation SetupRack Installation Power on LED Indicators Front Panel Identifying External ComponentsRear Panel LED Indicators10/100 NWay Ethernet/Fast Ethernet Switch LED Indicators Switch to PC Connecting SwitchSwitch to Hub with Uplink 10BASE-T Hub Hub without Uplink MDI-II portUsing straight cable General Technical SpecificationsPerformance Technical Specifications RJ-45 PIN SpecificationStandard Category 3 cable, RJ-45 pin assignment Page Offices Registration Card
Related manuals
Manual 20 pages 2.72 Kb
Top Page Image Contents