D-Link DES-1008M manual Port Module Installation, Connecting Power

Page 24

DES-1008M User’s Guide

Port Module Installation

The Switch supports various slide-in port modules which can be installed into the slots to provide interface to different network media like twisted- pair, thin coaxial cable, and fiber-optic cable. Four slide-in port modules are available for use with the Switch: DES-108FL, DES-108FX, DES-108TX, and DES-108C providing ST, SC, RJ-45, and BNC connectors, respectively. Each module comes with two switched ports, thus allowing maximum port configuration of eight switched ports.

Follow these steps to install a module,

1.Turn off the system (if already on), and unplug it from the power outlet.

2.Choose a slot to install the module. When choosing a slot, take into consideration the nodes you intend to connect to the module’s ports.

3.Remove the coverplate or module (if there is one installed) from the selected slot. Use the provided hex screwdriver to loosen and remove the screws. Set aside these screws.

4.Align the module with the railings on the slot, and then push the module all the way in until it locks into place.

5.Secure the module on the slot with the screws you removed in step 3. Use the same screwdriver to tighten the screws.

Connecting Power

The Switch features a power supply unit that automatically adjusts to the level of the input voltage. Supported voltage levels range from 100V to 240V AC at 50 to 60 Hz. Your local voltage level should fall within this range.

14

Installation

Image 24
Contents DES-1008M Flex-Media Ethernet Switch User’s Guide Wichtige Sicherheitshinweise Limited Warranty Link Offices for Registration and Warranty Service Limitation of Warranties Page Trademarks Page Table of Contents LIDE- in P ORT M Odules About this Guide TermsAbout this Guide Eight User-Configurable Ports Product OverviewBandwidth Boost Easy Installation Powerful PerformanceComprehensive LED Indicators Unpacking Component Identification UnpackingIndicator Panel Identifying External ComponentsPower Indicator Slots 1 to100M Indicator Link/Act IndicatorFDX/Col Indicator AC Power Connector System FanFuse Case Power Switch Installation Site InstallationRack Mounting Installation Port Module Installation Connecting PowerReplacing the Fuse Damaged one. Doing so may cause serious damage to the Switch Making Network Connections Network Design NotesCable Limitations Making Twisted-Pair Attachments Making Thin Coaxial Attachments Making Network Connections DES-1008M User’s Guide Making Fiber Attachments DES-1008M User’s Guide Technical Specifications 100BASE-FXNumber of Ports Safety Cables Connectors 10/100BASE-T Twisted-Pair Cable10BASE2 Thin Coaxial Cable 10BASE-FL/100BASE-FX Fiber- Optic Cable SLIDE-IN Port Modules DES-108TXDES-108C DES-108FL DES-1008M User’s Guide Index Slide-In Port Modules Offices Taiwan Link Taiwan Registration Card