Precautions / Safety Warnings, General | Altinex TNP100-HB specs

DESIGNER SOLUTIONS

PRECAUTIONS / SAFETY WARNINGS

Please read this manual carefully before using your TNP100-HBInterconnect Box. Keep this manual handy for future reference. These safety instructions are to ensure the long life of your TNP100-HBand to prevent fire and shock hazard. Please read them carefully and heed all warnings.

1.1GENERAL

∙Unauthorized personnel shall not open the unit since there are high-voltage components inside.

∙Qualified ALTINEX service personnel, or their authorized representatives must perform all service.

1.2INSTALLATION

∙For best results, place the TNP100-HBInterconnect Box in a dry area away from dust and moisture.

∙To prevent fire or shock, do not expose this unit to rain or moisture. Do not place the TNP100-HBInterconnect Box in direct sunlight, near heaters or heat radiating appliances, or near any liquid. Exposure to direct sunlight, smoke, or steam can harm internal components.

∙Handle the TNP100-HBInterconnect Box carefully. Dropping or jarring can damage internal components.

∙Never place fingers inside the opening on each side of the unit. This action could

cause serious injury because of the sharp edges inside of the TNP100-HB.

∙Do not place heavy objects on top of the TNP100-HB. Do not use excessive force to push down on the top of the unit.

∙To turn off the main power, disconnect the power cord, which powers the power socket on the TNP100-HBpop up panel. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible.

∙We recommend using wall outlets with a Ground Fault Circuit Interrupter (GFCI) for maximum protection.

∙Install all cables according to the instructions. Do not force or pull out any cable or power cord that is attached to the TNP100-HBInterconnect Box.

1.3CLEANING

∙Surfaces should be cleaned with a dry cloth. Never use strong detergents or solvents, such as alcohol or thinner. Do not use a wet cloth or water to clean the unit.

1.4FCC / CE NOTICE

∙This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

∙This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.