American Power Conversion Automatic Transfer quick start Quick Configuration, Overview

Page 11
Quick Configuration

Quick Configuration

Disregard the procedures in this section if you have APC InfraStruXure Manager as part of your system. See the InfraStruXure Manager’s

Warning documentation for more information.

Overview

You must configure the following TCP/IP settings before the Automatic Transfer Switch can operate on a network:

IP address of the Automatic Transfer Switch

Subnet mask

Default gateway

Note

If a default gateway is unavailable, use the IP address of a computer that is located on the same subnet as the Automatic Transfer Switch and that is usually running. The Automatic Transfer Switch uses the default gateway to test the network when traffic is very light. See “Watchdog Features” in the “Introduction” of the Automatic Transfer Switch User’s Guide for more information about the watchdog role of the default gateway.

TCP/IP configuration methods

Use one of the following methods to define the TCP/IP settings needed by the Automatic Transfer Switch:

Device IP Configuration Wizard (See “Device IP Configuration Wizard” on page 8.)

BOOTP or DHCP server (See “BOOTP & DHCP configuration” on page 8.)

Local computer (See “Local access to the control console” on page 10.)

Networked computer (See “Remote access to the control console” on page 15.)

Automatic Transfer Switch - Installation and Quick Start

7

Image 11
Contents Automatic Transfer Switch Installation and Quick StartThis manual is available in English on the enclosed CD How to Access the Automatic Transfer Switch Interfaces ContentsInstallation Quick ConfigurationPage Receiving inspection Preliminary InformationAdditional documentation Please recyclePreliminary Information Product inventory Automatic Transfer Switch  Rack-mount brackets  Front and rear rail segments  Communication cableFront panel OverviewAttach mounting brackets InstallationDisassemble the adjustable brackets Attach rear segments to the rack Attach front segments to the switchTwo people should perform this procedure Mount the Automatic Transfer Switch in the enclosureOverview Quick ConfigurationTCP/IP configuration methods Warning documentation for more informationBOOTP & DHCP configuration Device IP Configuration WizardTo create the bootup file, see your BOOTP server documentation Local access to the control console Web interface How to Access the Automatic Transfer Switch InterfacesHow to Access the Automatic Transfer Switch Interfaces Telnet/SSHSNMP FTP/SCP Configuring voltage transfer range Configuring the ATSConfiguring sensitivity Remote access to the control console 8. From the Control Console menu, select System, then User Manager Recovering From A Lost PasswordObtaining service WarrantyLimited warranty Warranty limitations5. Mark the RMA number clearly on the outside of the shipping carton Examples of life-support devices Life-Support PolicyGeneral policy Warning authority to operate this equipment Radio Frequency InterferenceChanges or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s990-1233E-001 APC Worldwide Customer Support990-1233E-001 10/2005