Configuring Spanning Tree
Configuring Classic Spanning Tree
Configuring Classic Spanning Tree
This section contains the following topics:
•Defining STP Properties
•Defining STP Interfaces
Defining STP Properties
The Spanning Tree Page contains parameters for enabling and configuring STP on the device. To enable STP on the device:
1.Click Layer 2 > Spanning Tree (STP). The Spanning Tree Page opens:
Figure 54: Spanning Tree Page
The STP General section of the Spanning Tree Page contains the following fields:
•Spanning Tree State — Indicates whether STP is enabled on the device. The possible field values are:
–Enable — Enables STP on the device.
–Disable — Disables STP on the device.
•STP Operation Mode — Specifies the STP mode that is enabled on the device. The possible field values are:
–Classic STP — Enables Classic STP on the device. This is the default value.
–Rapid STP — Enables Rapid STP on the device.
Page 89