Allied Telesis x600-24Ts-POE manual Led

x600 Series Layer 3 Gigabit Ethernet Switches Installation Guide

Figure 12 shows the port LEDs for the x600-24Ts-POE switch. These LEDs are located in the upper corners of each port.

LINK/ACT	PoE
LED	LED
LINK/ACT	PoE
LED	LED
	1467

Figure 12. Port LEDs on x600-24Ts-POE Switch

Table 3 describes the LEDs for the Base-T ports.

Table 3. Non-PoE Switch Base-T LED Descriptions

LED	Function	State	Description
L/A	Link Status	Off	No link has been established between
	and Activity		the port and the end node.
		Solid	The port has established a link at
		Green	1000 Mbps.
		Flashing	Packets are being received or
		Green	transmitted at 1000 Mbps.
		Solid	The port has established a link at 10
		Amber	or 100 Mbps.
		Flashing	Packets are being received or
		Amber	transmitted at 10 or 100 Mbps.
D/C1	Duplex	Solid	The port is operating in full-duplex
	Mode and	Green	mode.
	Collisions
		Solid	The port is operating in half-duplex
		Amber	mode (only applies when operating at
			10 or 100 Mbps).
		Flashing	Collisions are occurring on the port
		Amber	(only applies when operating at 10 or
			100 Mbps, half duplex mode).

33