Allied Telesis AT-GS900/16 Installing the Switch in a Rack, Attaching Rack Mounting Brackets

AT-GS900/16, AT-GS900/24 Gigabit eco-friendly Ethernet Switch Installation Guide

Installing the Switch in a Rack

Perform the following procedure to install the switch in a standard 19-inch rack. If you are not installing the switch in a rack, go to the next procedure.

1.Place the unit upside down on a level, secure surface.

2.If they have been previously installed, remove the self-adhesive rubber feet from the bottom of the switch, as shown in Figure 9 using a flat- head screwdriver.

Figure 9. Removing the Feet

3.Turn the switch over.

4.Attach the two rackmounting brackets (provided) to the sides of the switch using the eight flathead Phillips screws (provided), as illustrated in Figure 10.

24 Port
10/100/1000Base-T				AT-		GS900/24
			Gigabit
	1	3			Ethernet			Switch
			5	7		9	11
								13	15
										17	19			1
												21	23	3
POWER														5
	2	4	6											7	1000 LINK	ACT
				8	10										9		10/100
							12	14	16	18							11	LINK
											20							ACT	FDX
												22	24					13		HDX
																			15
																				COL
														2						17
														4						19
														6						21
														8						23
															10
																	12
																		14
																			16
																				18
																				20
																				22
																				24
																				1920

Figure 10. Attaching Rack Mounting Brackets

37