Allied Telesis 86251-08 manual PCR Module FILE, INSTALL, SCR Level, PCR Module Install Level

Page 10

10

Patch Release Note

PCR: 03778

Module: FILE, INSTALL, SCR

Level: 2

Files used during start up were backed up from NVS to FLASH even if they were already present in FLASH. This used up FLASH memory unnecessarily. This issue has been resolved so that files are only backed up when a copy does not already exist in FLASH.

PCR: 03780

Module: INSTALL

Level: 3

If a configuration file had a long file name, the SHOW CONFIG command displayed the file name using the shortened DOS 8.3 format (where file names are 8 characters long, with extensions of 3 characters). This issue has been resolved so that long configuration file names are now displayed using the DOS 16.3 format (where file names are up to 16 characters long).

PCR: 03783

Module: IPG

Level: 3

The TIMEOUT and SIZE parameters are only valid for the SET IP DNS CACHE command, but no error message was returned if either parameter was specified for the SET IP DNS command. This issue has been resolved.

PCR: 03784

Module: IPV6

Level: 3

Fragmentation of IPv6 packets now complies with RFC 2460’s requirement to align packet sizes to 8 octets.

PCR: 03789

Module: ETH

Level: 2

When a 4-port ETH PIC card was installed, the output of the SHOW IP INTERFACE command showed the ETH port as Down, but the link LEDs on the card were lit. This issue has been resolved. The SHOW command now shows the correct link status. The link will go down after 90 seconds if no inbound traffic is received. When inbound traffic is received the link will come up.

PCR: 03796

Module: STP

Level: 2

Setting RSTPTYPE to NORMAL, when normal has already been set, sets all ports to the “sending RSTP” state process. This is referred to in IEEE 802.1w as mCheck.

When RSTPTYPE was changed from STPCOMPATIBLE to NORMAL with the SET STP command, the STP instance continued to send STP BPDUs until an mCheck was performed by entering the SET STP RSTPTYPE=NORMAL command again. This issue has been resolved so that when RSTPTYPE is set to NORMAL an mCheck is performed, causing the STP to start sending RSTP BPDUs immediately.

PCR: 03801 Module: MLDS

Level: 2

MLD and MLD Snooping accepted MLD Query packets with a hop limit greater than 1. Duplicate packets were forwarded when the hop limit was not 1 and the payload was 0::0. This issue has been resolved. MLD and MLD Snooping now require the hop limit to be 1.

PCR: 03802

Module: FIREWALL

Level: 1

Packets with bad ACK numbers were sometimes generated by the firewall as part of the proxy TCP setup process. These packets sometimes caused TCP sessions from the public side of the firewall to fail. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Patch For Rapier Series Switches IntroductionPCR 03359 Module Core Level FeaturesPCR Module IPG Level PCR Module BGP LevelPCR Module STP Level PCR 03684 Module Core LevelPCR Module TTY, User Level PCR Module FIRE, Utility LevelPCR Module SW56 Level PCR Module Isakmp LevelPCR Module Ipsec Level PCR Module Firewall LevelPCR 31001 Module Dhcp Level PCR Module SWI LevelPCR Module IGP Level PCR Module Utility LevelPCR Module BGP Level PCR Module FFS Level PCR 31081 Module VRRP, IP, TCP, TelnetPCR Module File Level PCR 31098 Module Dhcp LevelPCR 02414 Module IPV6, SWI, IPG, Vlan PCR 31106 Module MLD LevelPCR Module IPX2 Level PCR Module IPGPCR Module ETH, IPG, IPv6, IPX Level PCR Module OSPF, IPG LevelPCR 03751 Module Mlds Level PCR Module ETH Level PCR Module FILE, INSTALL, SCR LevelPCR Module Install Level PCR 03801 Module Mlds LevelPCR 03823 Module Vlan Level PCR 03843 Module Dhcp LevelPCR Module DHCP, Telnet Level PCR Module IPG, IPV6 LevelPCR 03870 Module SWI, Vlan Level PCR Module TTY LevelPCR Module IP ARP Level PCR Module Switch LevelPCR Module Ikmp Level PCR Module Firewall Network affecting No PCR Module Ospf Network affecting No PCR Module L2TP LevelPCR Module PPP Level PCR Module PRI LevelPCR 03515 Module Dhcp Level PCR Module HTTP, Firewall Level PCR Module BGP, TCP LevelPCR 03547 Module Dhcp Level PCR Module Http Level PCR 03584 Module MLD Level PCR Module FIREWALL, IPG LevelPCR Module Ping Level PCR 03618 Module Dhcp Level PCR 03615 Module Load LevelPCR Module STP, SWI Level PCR 03647 Module Snmp Level PCR 03698 Module Dvmrp Level PCR Module PKI LevelPCR 03691 Module Dvmrp Level PCR 03708 Module Dhcp LevelPCR Module PPP, VJC Level PCR Module IP LevelPCR Module Vrrp Level PCR Module Rsvp LevelFeatures PCR Module IPSEC, Ikmp Level PCR 03371 Module Dhcp LevelPCR Module SSL Level PCR 03424 Module Dhcp Level PCR 03405 Module Stream LevelPCR 03410 Module VLAN, Core Level PCR 03429 Module SWI, Vlan LevelPCR 03443 Module Dhcp Level PCR 03436 Module IP, Dhcp LevelPCR Module IPX Level PCR Module FR LevelPCR 03465 Module Dhcp Level PCR 03492 Module HTTP, Load Level PCR Module BGP, Firewall LevelPCR 03515 Module Dhcp Level PCR 03089 Module Core Level PCR 02577 Module IPG, LOG LevelPCR Module GUI Level PCR 03094 Module STP, Vlan LevelPCR 03109 Module LOG Level PCR 03096 Module Vlan LevelPCR Module PIM, DVMRP, IPG Level PCR Module Classifier LevelPCR Module Cure Level PCR Module ETH, IPG LevelPCR Module IPG, SWI Level PCR Module Port LevelPCR Module PCI Level PCR 03153 Module ACC LevelPCR 03167 Module Dvmrp Level PCR Module LB Level PCR Module CORE, FFS, TTY LevelPCR Module FIREWALL, LB Level PCR Module User LevelPCR 03205 Module Dhcp Level PCR 03229 Module Load LevelPCR Module SWI, IPG, PIM Level PCR 03239 Module QOS LevelPCR 03247 Module MVR Level PCR 03256 Module MLD Level PCR Module VLAN, IPG LevelPCR Module DHCP, Q931, Telnet Level PCR 03346 Module Snmp Level PCR 03334 Module MVR LevelPCR 03336 Module Core Level PCR Module IP, SWI LevelPCR 03370 Module MVR Level VlanPCR 03388 Module Dhcp Level ADD PPP Create PPP Delete PPP SET PPP Show PPP PCR 03077 Module Core Level PCR 03067 Module Dhcp LevelPCR 03068 Module SWI, QOS Level PCR Module IPV6 Network affecting NoPCR Module PCI Network affecting No PCR Module SWI Network affecting NoPCR Module IPG Network affecting No PCR Module IPG, ETH Network affecting NoPCR Module TCP Network affecting No Availability Icmp Router Discovery AdvertisementsPCR Module TELNET, PING, IPV6, Network affecting No PCR Module TM Network affecting NoRouter Advertisement Messages To change these settings, use one of the commands ADD IP Interface SET IP Interface Disable IP Advertise Enable IP AdvertiseADD IP Advertise Interface Delete IP Advertise Interface SET IP Advertise Interface Example output from the Show IP Advertise command Show IP AdvertiseSame subnet Adopting the Vrrp IP Address MLD Snooping Ping Polling of Device Reachability Down device unreachable Enable and Disable Icmp Messages Icmp RedirectCommands Disable IP IcmpreplyStatic Igmp Show IP IcmpreplyConfiguration Example Commands Show IP IgmpSee Also Show IP Igmp Debug ADD IP Igmp Destination Create IP Igmp Destination Delete IP Igmp Destination Destroy IP Igmp DestinationDisable IP Igmp Debug Enable IP Igmp DebugChecking the Port Map on Rapier16fi Switches Show IP Igmp DebugHow to check that the port map is correct How to restore the correct port map PPPoE Client on Vlan Interfaces Force Eprom download Y ?ADD PPP Create PPP Delete PPP SET PPPVLANn-servicename, TNL- callname Show PPPShow PPP
Top Page Image Contents