Allied Telesis 86251-08 manual PCR 03205 Module Dhcp Level, PCR 03229 Module Load Level

Page 37

Patch 86251-08 For Rapier Series Switches

37

PCR: 03205 Module: DHCP

Level: 2

The following issues with DHCP have been resolved:

DHCP assigned an incorrect IP address to clients shifting from a relayed to a non-relayed range. Gateway checks have been added to resolve this issue.

DHCP clients shifting between relayed ranges were not always recognised, and were occasionally allocated incorrect addresses.

DHCP offered entries did not time out after a NAK on a bad lease time request.

PCR: 03206

Module: IPG

Level: 3

IPv4 filters now behave like IPv6 filters.

PCR: 03208

Module: FIREWALL

Level: 2

When the configuration script was created using the CREATE CONFIG command, the GBLIP parameter in the ADD FIREWALL POLICY command was listed twice. This caused the command to fail when the device was restarted. This issue has been resolved.

PCR: 03211

Module: SWI

Level: 2

When the MARL table had been fully populated, the addition of another multicast group caused an entry to be deleted, and the new entry was not added. This issue has been resolved so that no more groups can be added when the table is full.

PCR: 03212

Module: IPV6

Level: 3

The TRACE command was not working when using an ipv6 link-local address. This issue has been resolved.

PCR: 03213

Module: IPSEC

Level: 3

A memory leak occurred when some IPSEC processes failed. This issue has been resolved.

PCR: 03216

Module: PIM, PIM6

Level: 2

PIM4 and PIM6 were not sending Hello packets if the HELLOINTERVAL was not a multiple of 10. This is set with the ADD PIM INTERFACE, ADD PIM6 INTERFACE, SET PIM INTERFACE, and SET PIM6 INTERFACE commands. This issue has been resolved.

PCR: 03222

Module: PIM, PIM6

Level: 2

If the RP candidate advertising time was set to a non-default value with the ADVINTERVAL parameter in the SET PIM command, the hold time in the message was not being updated correctly. This issue has been resolved.

PCR: 03229 Module: LOAD

Level: 3

Zmodem was not naming some loaded files. This issue has been resolved.

PCR: 03232

Module: BGP

Level: 3

Values for the KEEPALIVE and HOLDTIME parameters in the ADD BGP PEER and SET BGP PEER commands were not interacting correctly. This issue has been resolved.

Patch 86251-08 for Software Release 2.5.1 C613-10356-00 REV I

Image 37
Contents Introduction Patch For Rapier Series SwitchesPCR Module IPG Level FeaturesPCR 03359 Module Core Level PCR Module BGP LevelPCR Module TTY, User Level PCR 03684 Module Core LevelPCR Module STP Level PCR Module FIRE, Utility LevelPCR Module Ipsec Level PCR Module Isakmp LevelPCR Module SW56 Level PCR Module Firewall LevelPCR Module IGP Level PCR Module SWI LevelPCR 31001 Module Dhcp Level PCR Module Utility LevelPCR Module BGP Level PCR Module File Level PCR 31081 Module VRRP, IP, TCP, TelnetPCR Module FFS Level PCR 31098 Module Dhcp LevelPCR Module IPX2 Level PCR 31106 Module MLD LevelPCR 02414 Module IPV6, SWI, IPG, Vlan PCR Module IPGPCR Module ETH, IPG, IPv6, IPX Level PCR Module OSPF, IPG LevelPCR 03751 Module Mlds Level PCR Module Install Level PCR Module FILE, INSTALL, SCR LevelPCR Module ETH Level PCR 03801 Module Mlds LevelPCR 03843 Module Dhcp Level PCR 03823 Module Vlan LevelPCR 03870 Module SWI, Vlan Level PCR Module IPG, IPV6 LevelPCR Module DHCP, Telnet Level PCR Module TTY LevelPCR Module IP ARP Level PCR Module Switch LevelPCR Module Ikmp Level PCR Module Firewall Network affecting No PCR Module L2TP Level PCR Module Ospf Network affecting NoPCR Module PPP Level PCR Module PRI LevelPCR 03515 Module Dhcp Level PCR Module HTTP, Firewall Level PCR Module BGP, TCP LevelPCR 03547 Module Dhcp Level PCR Module Http Level PCR 03584 Module MLD Level PCR Module FIREWALL, IPG LevelPCR Module Ping Level PCR 03618 Module Dhcp Level PCR 03615 Module Load LevelPCR Module STP, SWI Level PCR 03647 Module Snmp Level PCR 03691 Module Dvmrp Level PCR Module PKI LevelPCR 03698 Module Dvmrp Level PCR 03708 Module Dhcp LevelPCR Module IP Level PCR Module PPP, VJC LevelPCR Module Rsvp Level PCR Module Vrrp LevelFeatures PCR Module IPSEC, Ikmp Level PCR 03371 Module Dhcp LevelPCR Module SSL Level PCR 03410 Module VLAN, Core Level PCR 03405 Module Stream LevelPCR 03424 Module Dhcp Level PCR 03429 Module SWI, Vlan LevelPCR Module IPX Level PCR 03436 Module IP, Dhcp LevelPCR 03443 Module Dhcp Level PCR Module FR LevelPCR 03465 Module Dhcp Level PCR Module BGP, Firewall Level PCR 03492 Module HTTP, Load LevelPCR 03515 Module Dhcp Level PCR Module GUI Level PCR 02577 Module IPG, LOG LevelPCR 03089 Module Core Level PCR 03094 Module STP, Vlan LevelPCR Module PIM, DVMRP, IPG Level PCR 03096 Module Vlan LevelPCR 03109 Module LOG Level PCR Module Classifier LevelPCR Module IPG, SWI Level PCR Module ETH, IPG LevelPCR Module Cure Level PCR Module Port LevelPCR Module PCI Level PCR 03153 Module ACC LevelPCR 03167 Module Dvmrp Level PCR Module FIREWALL, LB Level PCR Module CORE, FFS, TTY LevelPCR Module LB Level PCR Module User LevelPCR 03229 Module Load Level PCR 03205 Module Dhcp LevelPCR Module SWI, IPG, PIM Level PCR 03239 Module QOS LevelPCR 03247 Module MVR Level PCR Module VLAN, IPG Level PCR 03256 Module MLD LevelPCR Module DHCP, Q931, Telnet Level PCR 03336 Module Core Level PCR 03334 Module MVR LevelPCR 03346 Module Snmp Level PCR Module IP, SWI LevelVlan PCR 03370 Module MVR LevelPCR 03388 Module Dhcp Level ADD PPP Create PPP Delete PPP SET PPP Show PPP PCR 03068 Module SWI, QOS Level PCR 03067 Module Dhcp LevelPCR 03077 Module Core Level PCR Module IPV6 Network affecting NoPCR Module IPG Network affecting No PCR Module SWI Network affecting NoPCR Module PCI Network affecting No PCR Module IPG, ETH Network affecting NoPCR Module TELNET, PING, IPV6, Network affecting No Availability Icmp Router Discovery AdvertisementsPCR Module TCP Network affecting No PCR Module TM Network affecting NoRouter Advertisement Messages To change these settings, use one of the commands ADD IP Interface SET IP Interface Disable IP Advertise Enable IP AdvertiseADD IP Advertise Interface Delete IP Advertise Interface SET IP Advertise Interface Show IP Advertise Example output from the Show IP Advertise commandSame subnet Adopting the Vrrp IP Address MLD Snooping Ping Polling of Device Reachability Down device unreachable Icmp Redirect Enable and Disable Icmp MessagesDisable IP Icmpreply CommandsShow IP Icmpreply Static IgmpConfiguration Example Show IP Igmp CommandsSee Also Show IP Igmp Debug ADD IP Igmp Destination Create IP Igmp Destination Destroy IP Igmp Destination Delete IP Igmp DestinationEnable IP Igmp Debug Disable IP Igmp DebugShow IP Igmp Debug Checking the Port Map on Rapier16fi SwitchesHow to check that the port map is correct How to restore the correct port map Force Eprom download Y ? PPPoE Client on Vlan InterfacesADD PPP Create PPP SET PPP Delete PPPShow PPP VLANn-servicename, TNL- callnameShow PPP