Allied Telesis Setup Guide for the AT-8624T/2M Model

10 AT-8600 Series Switch

9.Apply AC power to the switch

Plug the power cord into the AC power connector. This is on the switch’s rear panel, as shown in the below figures.

Figure 1: AT-8624T/2M front and rear panel with AC power inlet.

	1	3	5	7	9	11
25	26
	2	4	6	8	10	12

13	15	17	19	21	23												AT-8624T/2MLayer 3 Fast Ethernet Switch
																	MODE	RS-232	STATUS
						1	3	5	7	9	11	13	15	17	19	21	23	TERMINAL PORT
						LINK											COL		FAULT
						MODE											100		MASTER
						LINK											FULL		RPS
						MODE											ACT		PWR
14	16	18	20	22	24	2	4	6	8	10	12	14	16	18	20	22	24

Figure 2: AT-8624PoE front and rear panel with AC power inlet

	1	3	5	7	9	11
25	26
	2	4	6	8	10	12

13	15	17	19	21	23		100 LINK		ACT	10 LINK		ACT						AT-8624POELayer 3 Fast Ethernet Switch
							FULL DUP			HALF DUP		COL
							PD ON			PD ERR		MAX CURRENT					MODE	RS-232	STATUS
						1	3	5	7	9	11	13	15	17	19	21	23	TERMINAL PORT
																			FAULT
																			MASTER
																			RPS
																			PWR
14	16	18	20	22	24	2	4	6	8	10	12	14	16	18	20	22	24

Figure 3: AT-8648T/2SP front and rear panel with AC power inlet

	LINK	49R	MODE
49	LINK
SFP
	LINK
50	LINK	50R	MODE

AT-8648T/2SPLayer 3 Fast Ethernet Switch
STATUS
COL	FLT
SPD	MSTR
FDX	RPS
ACT	PWR
MODE

10.Check that the PWR LED on the switch’s front panel lights green

If the PWR (power) LED fails to light, refer to the AT-8600 Series Hardware Reference for troubleshooting information.

11.Connect the data cables

Make sure each cable connection is secure. The switch will now perform basic Layer 2 switching functions.