❏❏ 2. Test fit one of the wing hinges in the wing. The outer bearing should be flush with the wing tip. When satisfied with the fit, epoxy the hinge in place. Be careful to avoid getting epoxy into the open bearings.
❏❏ 3. Slide the loose carbon rod through the bearings.
❏❏ 4. Test fit an aileron onto the carbon rod as shown. If satisfied with the fit, glue the aileron to the carbon rod using CA. DO NOT glue the aileron to the bearings. The rod must freely rotate in the bearings, so the aileron must only be glued to the carbon rod.
Install the Servos
❏1. Remove the screws and servo arms from all of your servos. Enlarge the hole in the center of the extender until the head of the servo screw fits through.
❏2. Trim the mounting posts off of the servo as shown in the photo.
❏3. Place the original servo arm over the screw, and glue the top of the arm to the extender with CA. Some servo arms have small flanges projecting from the top. If your servo arms have these flanges, sand them off before gluing.
9