APC EP Zero ARF warranty Install the Tail Surfaces, Hinge the Ailerons

Page 8

Install the Tail Surfaces

❏1. Slide the stab into the slot in the rear of the fuselage. Center it as you did with the wing. Make sure the measurements shown in the sketches are equal. Glue the stab in place when satisfied with the fit.

❏2. Locate the 13.5" [343 mm] carbon elevator rod. Insert this rod into the preinstalled plastic bearings on the stab. DO NOT glue in place.

❏3. Use foam-safe CA to glue one of the elevator halves to the carbon elevator rod. Then glue the other elevator to the carbon elevator rod. Be sure the two halves are even as shown.

❏4. Glue the fin and rudder to the fuselage with epoxy. Make sure that the fin remains perpendicular to the stab and centered on the fuselage.

Hinge the Ailerons

❏❏ 1. Locate one of the carbon wing hinge assemblies. One of the carbon tubes is glued to the bearings; the other is free to rotate. Remove the loose carbon rod to prevent accidental gluing in the next steps.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Warranty AMA Table of ContentsIntroduction Lithium Battery Handling & Usage Protect Your MODEL, YourselfDecisions YOU Must Make TransmitterAdditional Items Required Ordering Replacement Parts Important Building NotesMetric Conversions Optional Supplies & ToolsKIT Contents KIT InspectionJoin the Wing to the Fuselage Building InstructionsJoin the Wing Halves Install the Tail Surfaces Hinge the AileronsInstall the Servos Install the Control Horns & Pushrods Install the Motor & Speed Control Final Setup Optional Combat Setup GET the Model Ready to FLYCheck the Control Directions Set the Control Throws4 83 mm Balance the Model C.GBalance the Model Laterally Motor Safety Precautions PreflightCheck List FlyingGeneral Radio ControlLanding LaunchFlight Great Planes ElectriFly U-Can-Do 3D EP ARF Other Items Available From Great PlanesGreat Planes ElectriFly Yak 55 EP 3D ARF Page Flight LOG
Top Page Image Contents