❏❏ 5. Apply a small spot of
❏❏ 6. Install a black nylon snap keeper onto the pushrod at the control horn.
❏7. Install the rudder and elevator pushrods in the same way as the ailerons. Use the
Install the Motor & Speed Control
❏1. Connect the output wires of your ESC to the motor. Check the direction of the motor before permanently installing it.
❏2. Install the ESC as shown using a small section of hook and loop tape. Place the hard “hook” side in the provided cutout in the fuselage and the softer “loop” side on the back of the ESC. If your ESC has a BEC switch, install it in the provided cutout. For some electronic speed controls, it may be necessary to trim the foam slightly to allow for wire clearance and switch mounting.
❏3. Slide the gearbox onto the square wood stick in the nose. Secure it with the supplied #2 x 3/8" [9.5 mm] screw.
11