ATEN Technology CS-1708 user manual SET Quick, View Ports, Accessible

OSD Operation

(F4 ADM: continued)

Setting	Function
SET QUICK	This function lets the Administrator select which Ports to include as
VIEW PORTS	Quick View ports.
	Note: Only the Ports currently chosen for the LIST view on the main
	OSD screen (see p. 26), show up here.
	w To select/deselect a port as a Quick View Port, use the
	Navigation Keys to move the highlight bar to it, then
	Press [Space].
	w When a port has been selected as a Quick View Port, an
	arrowhead displays in the QV column of the LIST on the Main
	Screen to indicate so. When a port is deselected, the
	arrowhead disappears.
	w If one of the Quick View options is chosen for the LIST view
	(see p. 26), only Ports that have been selected here will show
	up on the LIST display on the main OSD screen.
	w If one of the Quick View options is chosen for Auto Scanning
	(see p. 28), only Ports that have been selected here will be Auto
	Scanned.
	The default is for no ports to be selected.
SET	This function allows the Administrator to define User access to the
ACCESSIBLE	computers on the installation on a Port-by-Port basis. For each
PORTS	User, select the target Port; then press the [Spacebar] to cycle
	through the choices: F (Full access), V (View Only) or blank. Repeat
	until all access rights have been set, then press [Esc]. The default
	is F for all users on all Ports.
	Note: A blank setting means that no access rights are granted. The
	Port will not show up on the User’s LIST on the Main Screen.

(Table continues on next page)

31.

2004-04-27