Linksys SRW224 manual System Tab, Advanced Switch Configuration Figure

Page 26

24-port 10/100 + 2-Port Gigabit Switch with WebView

System Tab

The System tab displays the system information.

•Firmware version. The current firmware version is displayed.

•MAC Address. The MAC Address of the Switch is displayed.

•IP Address. This IP Address of the network is displayed. (The default IP address is 192.168.1.254. Verify the address. You can change the IP address, subnet mask, and default gateway here.

•Subnet Mask. The subnet mask of the network is displayed.

•Default Gateway. The default gateway of the network is displayed.

Click the Apply button after you have verified that the information is correct.

These following links are available on this tab:

To configure the advanced switch configuration, click the Click here to configure MISC configuration link.

To configure your username and password, click the Click here to configure your Username/Password link. (Figure 5-6)

To reboot your system, click the Click here to reboot system link.

To restore the Switch back to the default settings, click the Click here to restore system default setting link.

Advanced Switch Configuration (Figure 5-5.)

This screen allows you to make advanced switch configuration settings.

Broadcast Storm Filter. This allows you to filter by percentage the amount of broadcast traffic to your network to prevent a storm of too many broadcasts from being sent at the same time. Select 5%, 10%, or 20% from the drop-down menu. Select Off to prevent filtering.

Chapter 5: Configuring the Switch through the Web Utility

Figure 5-4: System Tab-System Information

Figure 5-5: System Tab-MISC Configuration

20

System Tab

Image 26

Contents Port 10/100 + 2-Port Gigabit Switch How to Use this Guide Copyright and TrademarksTable of Contents Port 10/100 + 2-Port Gigabit Switch with WebView List of Figures Front PanelAddrees Field Introduction WelcomeWhat’s in this Guide? Port 10/100 + 2-Port Gigabit Switch with WebView Ports Getting to Know the SwitchLEDs Back Panel Console Port RJ-45 PortsGigabit Expansion Ports Maximum Cabling Distances Connecting the SwitchOverview Positioning the Switch Pre-Installation ConsiderationsHardware Installation Fast Ethernet ConsiderationsPlacement Options Desktop PlacementUplinking the Switch Rack-Mount PlacementConfiguration using the Console Interface Configuring the HyperTerminal ApplicationSwitch Screens Configuring the Switch through the Console InterfaceLogin Switch Main MenuSystem Configuration System InformationAdvanced Switch Configuration Password ConfigurationIP Configuration Firmware UpdateRestore System Default Setting 14 Send FileReboot System Return to Main MenuLogout Port ConfigurationPort Status Configuring the Switch through the Web Utility Password ScreenAdvanced Switch Configuration Figure System TabPassword Setting System Tab-Username/Password SettingClick Apply when finished with your changes Port TabTrunk Tab Vlan Configuration802.1Q Vlan Mode Vlan TabAdvanced 802.1Q Vlan Setting Edit a 802.1Q Vlan GroupPortBased Vlan Mode Add a PortBased Vlan GroupQoS Configuration Logout TabAbout Gigabit Ethernet Appendix a Fast Ethernet and Gigabit EthernetAbout Fast Ethernet Crimping your own Network Cables Appendix B CablingTwisted Pair Cabling Figure B-2 Straight-Through Cable Fiber Optic Cabling Appendix D Glossary Port 10/100 + 2-Port Gigabit Switch with WebView Port 10/100 + 2-Port Gigabit Switch with WebView Port 10/100 + 2-Port Gigabit Switch with WebView Port 10/100 + 2-Port Gigabit Switch with WebView Port 10/100 + 2-Port Gigabit Switch with WebView Network Neighborhood/My Network Places Appendix C Windows HelpShared Resources Appendix E Specifications Appendix F Warranty Information Limited WarrantyAppendix G Regulatory Information FCC StatementAppendix H Contact Information