Linksys WAP11 v.2.6 manual Table of Contents

Page 3

INDUSTRY CANADA (CANADA)

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations.

EC DECLARATION OF CONFORMITY (EUROPE)

Linksys Group declares that the Instant Wireless® Series products included in the Instant Wireless® Series conform to the specifications listed below, following the provisions of the EMC Directive 89/336/EEC and Low Voltage Directive 73/23/EEC:

ETS 300-826, 301 489-1 General EMC requirements for Radio equipment.

EN 609 50 Safety

ETS 300-328-2 Technical requirements for Radio equipment.

Note: This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be restricted to certain frequencies and/or may require a license for operation. For more details, contact Linksys Corporate Compliance.

Note: Combinations of power levels and antennas resulting in a radiated power level of above 100 mW are considered as not compliant with the above mentioned directive and are not allowed for use within the European community and countries that have adopted the European R&TTE directive 1999/5/EC and/or the CEPT recommendation Rec 70.03. For more details on legal combinations of power levels and antennas, contact Linksys Corporate Compliance.

Linksys Group vakuuttaa täten että Instant Wireless Network Access Point tyyppinen laite on direktiivin 1999/5/EY, direktiivin 89/336/EEC ja direktiivin 73/23/EEC oleellisten vaatimusten ja sitä koskevien näiden direktiivien muiden ehtojen mukainen.

Linksys Group déclare que le point d’accès réseau sans fil est conforme aux conditions essentielles et aux dispositions relatives à la directive 1999/5/EC, la directive 89/336/EEC, et à la directive 73/23/EEC.

Belgique B L’utilisation en extérieur est autorisé sur le canal 11 (2462 MHz), 12 (2467 MHz), et 13 (2472 MHz).

Dans le cas d’une utilisation privée, à l’extérieur d’un bâtiment, au-dessus d’un espace public, aucun enregistrement n’est nécessaire pour une distance de moins de 300m. Pour une distance supérieure à 300m un enregistrement auprès de l’IBPT est requise. Pour une utilisation publique à l’extérieur de bâtiments, une licence de l’IBPT est req- uise. Pour les enregistrements et licences, veuillez contacter l’IBPT.

France F: Bande de fréquence restreinte: seuls les canaux 10, 11, 12, 13 (2457, 2462, 2467, et 2472 MHz respectivement) doivent être utilisés en France. Toute utilisation, qu'elle soit intérieure ou extérieure, est soumise à autorisation. Vous pouvez contacter l'Autorité de Régulation des Télécommuniations (http://www.art-telecom.fr) pour la procédure à suivre.

France F: Restricted frequency band: only channels 10, 11, 12, 13 (2457, 2462, 2467, and 2472 MHz respectively) may be used in France. License required for every indoor and outdoor installations. Please contact ART for procedure to follow.

Deutschland D: Anmeldung im Outdoor-Bereich notwending, aber nicht genehmi- gungspflichtig. Bitte mit Händler die Vorgehensweise abstimmen.

Germany D: License required for outdoor installations. Check with reseller for procedure to follow.

Italia I: E' necessaria la concessione ministeriale anche per l'uso interno. Verificare con i rivenditori la procedura da seguire. L'uso per installazione in esterni non e' permessa.

Italy I: License required for indoor use. Use with outdoor installations not allowed.

the Netherlands NL License required for outdoor installations. Check with reseller for procedure to follow.

Nederlands NL Licentie verplicht voor gebruik met buitenantennes. Neem contact op met verkoper voor juiste procedure.

Wireless Network Access Point

Table of Contents

Chapter 1: Introduction

1

The Instant Wireless Network Access Point

1

Features

1

Chapter 2: Planning Your Wireless Network

2

Network Topology

2

Ad-Hoc versus Infrastructure Mode

2

Chapter 3: Getting to Know the Wireless Network

 

Access Point

4

The Wireless Network Access Point’s Ports

4

The Wireless Network Access Point’s LEDs

5

Chapter 4: Connecting the Wireless Network

 

Access Point

6

Chapter 5: Setting Up the Wireless Network

 

Access Point

7

Chapter 6: Configuring the Wireless Network

 

Access Point

15

The Setup Tab

15

The Password Tab

21

The Status Tab

22

The Log Tab

24

The Help Tab

25

The Filter Tab

26

The Wireless Tab

28

Appendix A: Troubleshooting

31

Frequently Asked Questions

31

Appendix B: Setting Up the TCP/IP Protocol

35

Setting Up TCP/IP in Windows

35

TCP/IP Setup for Windows 98 and Millennium

36

TCP/IP Setup for Windows 2000

37

TCP/IP Setup for Windows XP

38

Image 3
Contents Wireless Network Access Point Mail Table of Contents Instant Wireless Network Access Point FeaturesIntroduction Planning Your Wireless Network Ad-Hoc versus Infrastructure ModeNetwork Topology Wireless Network Access Point’s LEDs Wireless Network Access Point’s PortsConnecting the Wireless Network Access Point Instant Wireless Series Instant Wireless Series Instant Wireless Series Setup Tab Configuring the Wireless Network Access PointSetting WEP Encryption Setting the AP Mode Password Tab Status Tab LANHelp Tab Log TabFilter Tab Wireless Tab Frequently Asked Questions Appendix a TroubleshootingWhat is infrastructure mode? Setting Up TCP/IP in Windows What is a MAC Address?TCP/IP Setup for Windows TCP/IP Setup for Windows 98 and MillenniumAppendix C Glossary TCP/IP Setup for Windows XPInstant Wireless Series Instant Wireless Series Instant Wireless Series Appendix D Specifications Environmental Appendix E Warranty InformationAppendix F Contact Information Copyright 2003 Linksys, All Rights Reserved