AB Soft N8406-026 manual Installing and Removing XFP Module, Avoid direct look into the laser beam

(English)

Installing and Removing XFP Module

The following is described how to install and remove N8406-027 10GbE XFP Module in and from N8406-026 10Gb Intelligent L3 Switch.

IMPORTANT:

・Attach the dust covers to all vacant LC connectors to protect them

from contamination, if you store or transport the Switch Module which the XFP modules are installed.

・ Optical power and sensitivity may be lower and cause malfunction by coming into contact with contamination.

・ Install the XFP module to the XFP module slot straight. Do not force

to install it to avoid damage the module.		XFP Module
	Dust cover

WARNING

Avoid direct look into the laser beam.

The N8406-027 10GbE XFP Module is classified as a Class 1 Laser Product. A class 1 laser will not be harmful to the human body. However, do not look directly into the XFP module port during operation. Keep any vacant LC connector covered with a dust cover (rubber cap) when you do not use it or you transport it.

Installing XFP Module

1

2

Remove the dust cover attached to the XFP module.

Insert the XFP module to the XFP	XFPmoduleslot
module slot in the Switch Module.	N8406-026

XFPmodule

NOTE: Insert the XFP module to the XFP module slot without pulling down the lever. If you insert with the lever pulled down, a communication failure may occur.

32