Advantech PCM-9588 user manual General Introduction

	VGA port
Display	18/36-bit TTL
	DVI (36 bit)
	LVDS (48 bit)
	Intel GMA 900,(166 MHz/160 MHz @1.05v)
	2D Display core frequency support from 133 MHz & 190/200 MHz @ Vcc =
	1.05 / 1.5 V
	depending on Host/Memory configuration
	3D Render core frequency support from 133 MHz & 160/166 MHz @ Vcc =
	1.05 / 1.5 V
Features	depending on Host/Memory configuration
	Two SDVO ports multiplexed with PCI Express graphic interface
	Dual Channel LVDS interface support 36 bits
	CRT monitor resolutions supported:
	Supports up to QXGA(2048x1536)
	LVDS panel resolution supported:
	Supports up to SXGA (1400x1050)
	Dual independent display options with digital display

	Analog CRT DAC interface support
	Supports max DAC frequency up to 400 MHz
VGA	24-bit RAMDAC support
	DDC2B compliant
	Digital/Analog Converter for CRT: QXGA (2048x1536)
	able to drive a DFP display at a pixel rate of up to 165MHz
DVI	supporting UXGA (1600x1200) resolution displays.
	Digital Visual Interface (DVI) Transmitter up to 165M pixels/second
	supports from CH7307
	LVDS: Up to SXGA (1400x1050) --- 910GMLE Integrated dual channel
	LVDS interface supported on Display Pipe B only
	Supports 25 to 112 MHz single/dual channel LVDS interface:
	Single channel LVDS interface support: 1 x 18 bpp
	Dual channels LVDS interface support: 2 x 18 bpp
	Maximum Wide panel size supported up to WUXGA
	Ambient Light Sense support for automatic backlight brightness adjustments
	Intel Display Power Savings Technology 2.0 support
	Supports Single pipe simultaneous display with the CRT DAC and the LVDS
	ports under the following conditions:
LVDS	Timings must match for both display
	Panel Fitting. Panning, and Center mode supported Spatial Dithering sup-
	port to emulate up to 16 million colors for 18bpp TFT panels.
	Spread spectrum clocking (SSC) supported Supports down and center SSC
	via an SSC clock from an external SSC clock chip.
	Supports down spread of - 2.5% or center spread of ± -1.25% in reference
	30-50 kHz modulation rate SSC must be disabled for LVDS port and CRT
	DAC single pipe simultaneous display mode.
	Panel Power Sequencing support
	Power down state can be either zero volt or high impedance
	Integrated PWM interface for LCD Backlight Inverter Control
TTL	Supports up to 1600x1200x32 bpp at 60 Hz 18,36-bit, TTL signal supports
	via NS_DS90C3202
	Intel GMA 900,
Internal	910GMLE:
	2D Display core frequency support from 133 MHz & 190/200 MHz @ Vcc =
Graphics Fea-
	1.05 / 1.5 V depending on Host/Memory configuration
tures	3D Render core frequency support from 133 MHz & 160/166 MHz @ Vcc =
	1.05 / 1.5 V depending on Host/Memory configuration

Chapter 1 General Introduction

3 PCM-9588 User Manual