Advantech SPC-530 user manual Appendix C Safety Instructions, Do not Cover the Openings

Page 17

Appendix C Safety Instructions

1.Please read these safety instructions carefully.

2.Please keep this User's Manual for later reference.

3.Please disconnect this equipment from any AC outlet before cleaning. Do not use liquid or sprayed detergent for cleaning. Use a moist sheet or cloth.

4.For pluggable equipment, the socket-outlet must be installed near the equipment and must be easily accessible.

5.Please keep this equipment free from humidity.

6.Lay this equipment on a reliable surface when installed. A drop or fall could cause damage.

7.The openings on the enclosure are for air convection, so protect the equipment from overheating.

DO NOT COVER THE OPENINGS.

8.Make sure of the voltage of the power source when connecting the equipment to the power outlet.

9.Position the power cord such that people cannot step on it. Do not place anything over the power cord.

10.All cautions and warnings on the equipment must be noted.

11.If the equipment is not used for a long time, disconnect it from the mains. This prevents the equipment from being damaged by transient overvoltage.

12.Never pour any liquid into an opening. This can cause fire or electrical shock.

13.Never open the equipment. For safety reasons, the equipment should only be opened by qualified service personnel.

14.If one of the following situations arises, get the equipment checked by service personnel:

a.The power cord or plug is damaged.

b.Liquid has penetrated into the equipment.

c.The equipment has been exposed to moisture.

d.The equipment does not work well or you cannot get it to work according to the user's

manual.

e. The equipment has been dropped or damaged.

f. The equipment has obvious signs of breakage.

15.DO NOT LEAVE THIS EQUIPMENT IN AN UNCONDITIONED ENVIRONMENT WITH STORAGE TEMPERATURES BELOW -20oC (-4oF) OR ABOVE 60oC (140oF), AS THIS MAY DAMAGE THE EQUIPMENT.

The sound pressure level at the operator's position according to IEC 704-1:1982 is equal to or less than 70 dB(A).

14 SPC-530 User's Manual

Image 17
Contents SPC-530 Copyright Notice Acknowledgments Contents Model list SpecificationsGeneral Information Introduction Passive backplane options for SPC-530BP / SPC-530BP-U2C Fault detection and alarm notification Dimensions Removing the cover System SetupCooling fans Removing the handlesTemperature setting Installing the disk drivesInstalling the power supply unit Appendix a Backplanes Optional Resistor SignalsPage Page Appendix B Exploded Diagrams SPC-530BP Do not Cover the Openings Appendix C Safety Instructions