![](/images/new-backgrounds/1143866/14386673x1.webp)
T E L N E T C O N S O L E C O M M A N D S A
Use this appendix to configure the print server using Telnet. You
must have a basic understanding of Telnet commands. For initial setup, do not use Telnet. Use
You can use Telnet if you do not have access to the
NOTE: The default port is Port 23.
To reset the unit back to factory defaults, press and hold the black button on the print server card for about ten seconds. The LEDs will temporarily turn off and then back on, indicating the unit is resetting.
To access Telnet console mode:
1. Start Telnet.
2. Press Enter (on your host) until you see the “#” prompt.
3. Type “access” as the password and press Enter. (“Access” is the default password.)
4. Press Enter to
Telnet Console Commands